Paver Repair in Naples, FL
Call us: 239-595-8046
Pavers don't usually fail on their own. When a driveway starts to dip, a patio rocks underfoot, or water sits on the pool deck, something underneath has moved: the base, the edge, or the sand in the joints. The good news is that a paver surface can almost always be repaired without tearing the whole thing out. Over the last 15 years, Sosa Group has installed thousands of paver patios and driveways across Southwest Florida, and we always build to manufacturer specifications. We primarily work with TriCircle and Belgard Paving Stones, so we know exactly what should be under your pavers and how to bring a tired surface back to level. We strive to educate our customers as much as possible, so keep reading to see what causes paver problems and how we fix them. Want the full breakdown of what causes sinking pavers in Naples and how each one gets fixed? Read our guide: Sinking Pavers Naples FL — 5 Causes & Fixes
Not sure if you need a repair or a full replace? See our Naples repair vs replace checklist.
How Paver Repair Works
What's Under a Paver Repair?
We repair the same way we install. Every repaired area gets a compacted base of crushed concrete (RCA), a fine layer of mason sand for leveling, the pavers reset flush with the surrounding surface, a concrete edge to hold the perimeter, and fresh sand swept into the joints to lock everything in place. (See below for more detailed information.)
Sinking Pavers & Driveway Repair in Naples
Sinking pavers, low spots that hold water, raised edges, and loose borders are the most common calls we get. Most paver repair in Naples doesn't mean replacing the whole driveway — we pull up the affected area, fix the base underneath, and reset your existing pavers so the repair blends in. Typical problems we fix:
- Sinking or settling pavers on driveways, walkways, and pool decks
- Ruts and dips where cars park or turn
- Pavers lifted by tree roots
- Loose or shifting border/soldier courses
- Washed-out joint sand and weeds in joints
- Cracked or broken pavers (swapped with matching stock when available)
Why Pavers Sink in SWFL
- Sandy soil and heavy rain. Summer storms move water under the pavers; if the base wasn't compacted well, the sand washes out and the pavers drop.
- Poor drainage. Downspouts, sprinklers, and low spots dump water in the same place every day.
- Thin or uncompacted base. Driveways need a base built for vehicle weight; shortcuts show up as ruts.
- Failing edge restraint. When the border moves, the field pavers spread and settle.
- Tree roots. Roots lift pavers in one spot and leave voids in another.
- Utility trenches and old fill. Soil dug for irrigation or plumbing lines often keeps settling for years.
Our Paver Repair Process
1. Inspect & find the cause – We look at drainage, roots, edges, and the base so the same spot doesn't sink again.
2. Lift & save your pavers – We remove pavers in the problem area and stack them for reuse.
3. Rebuild the base – Remove bad material, add and compact new base and bedding sand, and correct slope away from the house or pool.
4. Reset, restrain & compact – Reinstall pavers in the original pattern, secure edges, and compact so the repair matches the surrounding area.
5. Sand the joints & walk through it with you – Refill joints (polymeric sand where appropriate), clean up, and review the finished work. Ask us about sealing afterward if you want extra protection.
Repair or Replace?
If the problem is a few areas, repair is usually the practical choice. If most of the driveway is moving, pavers are badly broken, or the original base was never built right, we'll tell you honestly when replacement makes more sense.
HOA & Permit Notes
Many Naples communities have HOA rules on paver color, pattern, and contractor access. Check with your HOA before work starts, and confirm with Collier County (or Lee County for Bonita Springs/Estero) whether your project needs a permit. We're happy to help you gather what your HOA asks for.
Get Your Paver Repair Estimate
Send us a few photos of the sinking or damaged area, or call 239-595-8046. We'll take a look and tell you what it needs.
The first step in any repair is figuring out the cause. Sinking spots and uneven pavers almost always point to a base that settled or washed out, often from heavy summer rain, irrigation runoff, or a base that was never compacted properly. Weeds and ant hills in the joints mean the joint sand has washed or blown out. Puddles mean the pitch is off. Pavers creeping out at the edges mean the edge restraint has failed. Once we know what went wrong, we fix that first, so the problem doesn't come back next rainy season. Lifting & Rebuilding the Base: With the problem area marked, our crew carefully pulls up the affected pavers and sets them aside so they can be reused. We dig out the soft or washed-out material, compact the ground underneath, and install new RCA (Recycled Concrete Aggregate) in layers, compacting each lift with a plate compactor until the base is back to the right height. Next, we spread a layer of fine sand over the RCA, tamp it down, and screed it smooth. This sand bed is what lets us bring the repaired pavers back level with the rest of your driveway, patio or pool deck. Driveways & Pool Decks: Driveways carry the most weight, so ruts, low spots near the apron and shifting edges show up there first. On driveway repairs we rebuild the base where tires have pushed it down and lock the perimeter back in so it holds up to daily traffic. If your driveway is past the point of repair, see our driveway installation page. Pool decks deal with constant water, splash-out and foot traffic. We reset sunken, loose or rocking pavers and travertine around the pool and correct the slope so water runs off the deck instead of sitting on it.
Finding Out Why Your Pavers Moved
Edges, Joints & Final Stages of Repair
Once the pavers are reset, we restore the concrete edge along any exposed perimeter. This edge acts as a restraint, keeping the pavers in place and preventing them from shifting or spreading over time. The concrete is set about 1 inch below the top of the pavers and covered with topsoil for a clean finish. To finish, we sweep sand into the joints and mist it with water to activate and set it to a hard finish. This locks the pavers together, discourages weeds and ants, and adds long-term stability to the repaired area. Cracked or chipped pavers can be pulled and replaced individually, and we'll match your existing color as closely as possible. Setting the Pitch for Proper Drainage: Standing water on pavers is usually a grade problem. When we reset a section, we build in a slight "pitch," typically about 1.5 inches of slope for every 10 feet, angled away from your home. That keeps water moving off the surface while still giving you a level, comfortable feel underfoot. Paver Sealants: After a repair, sealing is a great way to bring back that rich, wet look your pavers had when they were new. Sealing also locks in the joint sand, helping keep it from washing or blowing out, which is one of the most common reasons pavers need repair in the first place. Borders: A loose or separating border is one of the first signs a paver surface is starting to move. We reset single, matching or double borders back to their original line so the edge of your driveway, patio or walkway looks crisp again and holds everything inside it in place.
Frequently Asked Questions
What affects the cost of a paver repair?
The size of the area, how far the base has failed, whether pavers can be reused or need replacing, matching discontinued colors, and access to the site. We give you a clear quote after seeing the problem in person.
How long does a paver repair take?
Most small repairs — a sunken section, a few cracked pavers, a lifted edge — take a day or less. Larger areas with base problems can take longer. We'll give you a timeline with your quote.
Why are my pavers sinking?
Usually it's the base underneath: not enough compaction when installed, washout from heavy rain or a downspout, broken irrigation, tree roots, or missing edge restraint. We lift the pavers, fix the base, and reset them so the problem doesn't come right back.
Should I repair or replace my pavers?
If the problem is limited to certain spots and the pavers are in good shape, repair is usually the smart choice. If most of the area is sinking, cracked, or faded, replacement may make more sense. We'll tell you honestly which one fits.
How do I stop weeds and ants between pavers?
Weeds and ants move in when joint sand washes out. Re-sanding the joints — often with polymeric sand — and sealing helps lock the joints and keep them out longer.
Should I seal my pavers after a repair?
Sealing is optional but helps. It can protect the joint sand, help repaired spots blend in, and resist stains. Fresh repairs may need time to settle before sealing; we'll let you know when.
Do I need HOA approval for paver repair?
Many Naples communities require approval for changes to color, pattern, or layout, and some for any exterior work. Like-for-like repairs often need less, but check with your HOA. We're happy to provide details or samples for your application.
For warranty, payments, sprinklers, and paver maintenance tips, see our Playbook: https://www.sosagroupfl.com/playbook
Areas We Serve
Sosa Group installs and repairs pavers, driveways, patios, and pool decks across Southwest Florida — including Naples, North Naples, East Naples, Golden Gate, Marco Island, Bonita Springs, and Estero. We work with TriCircle and Belgard pavers and travertine, and every project starts with an on-site look at your space. Call 239-595-8046 or visit us at 2034 44th Ter SW, Naples, FL 34116.
Contact Us
Have questions? Want to get started? Reach out! We are available during normal business hours.
​
